Envirolak 200 series topcoat ELNYW200 is a water based 1k or 2k opaque finish that looks and feels like conventional varnish.

Envirolak 200 series can be mixed 10% by weight or volume with CAT100-LV hardener and used as a 2K system. 200 is based on a polyurethane dispersion. It is a high build coating and suitable for tough environments like kitchens and baths.

This product has excellent leveling and anti-sag properties for vertical applications. 200 series was recently reformulated for a softer feel, and better vertical hang!

200 can be accurately tinted into custom colors from Benjamin Moore, Behr, Sherwin Williams and more. Depending on order volume, custom colors may not ship when ordered before 3PM. Current order cutoff time for custom colors is posted daily and can be found at the top of every page.

Dry Times:

To touch: 20 minutes

To sand: 2 hours

To recoat: As a 1K - 4 hours at 4 mils, and 6 hours at 6 mils. 

As a 2K recoat time is 2-3 hours at 4-6 wet mils.

Typical 2K system in a light color:

Products needed are ELPRT170 primer, CAT100-LV hardener, and this product, ELNYW200 in the sheen of your choice.

Apply a coat of 170 Primer with 5% CAT100-LV Hardener (2 hour pot life)

Sand using 320 grit sandpaper and refine with very fine or super fine sanding sponges.

(Optional) 2nd Primer Coat 170 primer OR 170TB primer with 5% CAT100-LV hardener  

Level sand using 320 grit sandpaper and refine with super fine sponges.

1st Topcoat of 200 series ELNYW200, add 10% CAT100-LV Hardener (2 hour pot life)

If applying an optional 2nd coat, wait 2-3 hours and sand using 320 grit sandpaper. Refine with super fine sanding sponges.

(Optional) 2nd Topcoat ELNYW200, add 10% CAT100-LV Hardener (2K) 

Recommended Spray Application & Technical Information:

Reduction is not required if spraying through a pump, but the product may be reduced with water or ELRX010 Reducer to improve application characteristics.

Note: When used as a 2K product with CAT100-LV the gloss of the 200 series will increase with each percentage of hardener. 20 sheen is recommended, if you’re looking for a true satin finish. 

Recommended Spray Application & Technical Information

Air Assisted Airless: 

Fluid Pressure: 500-700 PSI. Air Pressure: 25 PSI (triggered) Tips: 06, or 09.

Airless:

Fluid Pressure: 1200-2000 PSI - Tip size: 308, 310, or 408, 410 fine finish or ultra finish.

HVLP (Turbine):

Air Pressure: Max - Needle size: 1.5-1.8 reduce at 2-5% with ELRX010 reducer.

Cup Gun (gravity) Air Pressure: 40 PSI - tip size: 1.8  reduce at 2-5% with ELRX010

200 series should be applied at 4-6 wet mils.